Table of Contents
Advertisement
WARNING! These instructions are written
based on commonly available IR repeaters that
mount in a
1
/
2
this installation, please refer to the instructions
that came with your IR repeater to verify this
hole size. If your IR repeater requires a hole size
other than
1
/
2
tions accordingly. Before drilling the mounting
1
hole, a
/
" pilot hole should always be drilled
8
from the back regardless of the final mounting
hole diameter.
Required tools (not included):
Electric drill
1
/
" drill bit
8
1
/
" drill bit
2
1
Prepare a flat surface with a cushion and/or blanket to
protect the Voyage. Place the Voyage driver side down.
WARNING! Be careful to put no weight on
the tweeter globe.
2
From the rear of the speaker and at the location shown
in figure 13, use a
1
/
8
3
Turn the Voyage over so that it is driver side up.
4
From the front of the speaker, use a
widen the hole for the IR repeater.
5
Follow the instructions that come with the IR repeater to
finish installation.
" diameter hole. Before beginning
" diameter, adjust these instruc-
" drill bit to drill a pilot hole.
1
/
" drill bit to
2
I
NSTALLING AN
Figure 13. Installing an IR repeater—location to drill hole.
IR R
EPEATER
Installing an IR Repeater
9
Advertisement
Table of Contents
