Table of Contents
Advertisement
I
NSTALLATION
WARNING! Installation other
than that described in the body of
this document requires specific
documentation from MartinLogan.
Fig. 5
F
A
REQUENTLY
SKED
How do I clean my speakers?
Use a dust free cloth (such as a micro fiber cloth)
or a soft brush to remove dust from your speakers.
Do not spray any kind of cleaning agent on or in
close proximity to the drivers.
Could you suggest a list of suitable elec-
tronics and cables ideal for MartinLogan
speakers?
We have no favorites and use electronics and
cables quite interchangeably. We would suggest
listening to a number of brands—and above all
else—trust your ears. Dealers are always the best
source for information when purchasing additional
audio equipment.
BREAK IN
Allow approximately 72 hours of break-in at 90
dB (moderate levels) before any critical listening.
INSTALLING ON A FLAT SURFACE
If you have a surface that provides a wide, level,
and stable platform, the speaker can be placed
directly on top. When using the speaker in this
configuration, affix the pads to the bottom of the
speaker at the rear contact points (fig. 5). Note:
This speaker is not magnetically shielded and
therefore should not be placed directly beside or
atop a CRT television.
Toe-In: When installed on a surface and used as
front channels we recommend aiming your speak-
ers towards the primary listening position.
Q
UESTIONS
Is there likely to be any interaction
between my speakers and the televi-
sion in my A/V system?
Yes. These speakers are not shielded and should
be kept at least 2 feet away from a CRT television.
Will exposure to sunlight affect the life
or performance of my speakers?
We recommend against placing any loudspeaker
in direct sunlight. Ultraviolet (UV) rays from the sun
can cause deterioration of cabinet, speaker cones,
etc. Small exposures to UV will not cause a prob-
lem. Filtering of UV rays through glass will greatly
reduce the negative effects.
7
Advertisement
Table of Contents
