Troubleshooting - Hoover HSV87-LX1-ID User Manual

To reduce the risk of personal injury, remove battery pack before
performing maintenance/troubleshooting checks.
prOBleM
Vacuum won't
turn on
Product turns off
while in use
Vacuum won't
pick up properly
Brushbar won't
rotate
LED is not lit
when the battery
is inserted into
the charger
LED flashes twice
followed by a 1
sec. off period
LED is flashing
continually
LED flashes/stays
lit after battery is
removed

4. trOuBleshOOting

IMPORTANT
!
pOssiBle Cause
1. Battery is not correctly inserted
into the product.
2. The battery in not charged.
3. Battery is too hot.
4. The motor Thermostat has
tripped.
1. Battery is discharged.
2. Battery is too hot.
3. The motor Thermostat has
tripped.
1. The dirt container is full.
2. Dirt container is not installed
correctly.
3. Filter is clogged.
4. The separator is clogged
5. The air path/brush bar is blocked.
1. Brushbar switch is off.
2. Brushbar is blocked.
1. Wall charger is not plugged in.
2. Battery is inserted incorrectly
into the charger.
3. The battery is not communi-
cating with the charger.
1. The battery is too hot or cold.
1. Battery is inserted incorrectly
into the charger.
2. The battery or charger has
detected an error.
1. This is normal if within 10 sec
of battery removal.
!
pOssiBle sOlutiOn
1. Check the battery is inserted correctly
into the product. (Pg. 5)
2. Remove and charge battery.
3. Remove and let cool for 30 minutes.
Replace battery.
4. Switch off and unplug the vacuum cleaner.
Leave for one hour before switching the
vacuum cleaner back on.
1. Remove and charge battery.
2. Remove and let cool for 30 min. Replace battery.
3. Switch off and unplug the vacuum cleaner.
Leave for one hour before switching the
vacuum cleaner back on.
1. Refer to Emptying and Cleaning the
Dirt Container. (Pg. 8)
2. Remove the dirt container from the unit by
pressing the dirt container release button
(Pg. 8) and reattach it to the unit, ensuring it
is locked firmly back into place.
3. Refer to Cleaning the Filter (Pg. 8)
4. Refer to Advanced Cleaning (Pg. 8)
5. Refer to Removing Blockages (Pg. 9)
1. Refer to Maintenance (Pg. 8).
2. Refer to Removing Blockages (Pg. 9)
1. Check that the wall charger is plugged in.
2. Check the battery is inserted correctly into
the charger (Pg. 5).
3. Remove battery and unplug charger, wait
10 seconds, then plug charger into socket
and reinsert battery.
1. Leave the battery in the charger. When
the battery reaches the correct temperature,
the battery will start charging automatically.
1. Check the battery is inserted correctly into
the charger.
2. Remove battery and unplug charger, wait
10 seconds, then plug charger into socket
and reinsert battery.
1. If it still flashes after 10 seconds, unplug
charger, wait 10 sec., then plug charger
into socket.
10