Operate cleaner only at voltage specified on data plate on bottom of cleaner. If you need assistance: Visit our website at hoover.com. Click on the “Customer Service” link to find the service outlet nearest you OR Call 1-800-944-9200 for an automated referral of authorized service outlet locations (U.S.
• Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a Hoover Factory Service Center or Authorized Hoover Commercial Warranty Service Distributor.
Grounding Instructions This appliance must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electrical current to reduce the risk of electric shock. This appliance is equipped with a cord having an equipment- grounding conductor (C) and grounding plug (A).
1. HOW TO USE Carpet Height Adjustment It is necessary to raise and lower the nozzle for various carpet pile heights. Turn the control to the desired adjustment for carpet pile height according to the chart below. For cleaning glue-down carpet and removing loose dirt from hard surface. For short pile and kitchen type carpet.
Page 6
Optional Paper Throw Away Bag A HOOVER® Type A paper throw away bag may be used with the cleaner in place of the cloth dirt bag. Remove cloth dirt bag from cleaner following directions previously given and remove bag closure clip from dirt bag.
Page 7
The Dirt Cup The dirt picked up by the cleaner is deposited into the dirt cup. When empty, the cup can be cleaned with a damp cloth or rinsed with water. Be sure cup is dry before re-using. When to Empty Frequently check dirt level in the dirt cup.
Page 8
Use only genuine HOOVER belts with your Reposition hood and bottom plate. cleaner. When purchasing a new Flat Belt, ask for Replace hood and bottom plate screws. HOOVER part No. 38528036. When purchasing a new V-Belt, ask for HOOVER part No. 38528013. Tighten screws with screwdriver.
Page 9
Use only genuine HOOVER agitator roll sleeves with your cleaner. For the Conquest 14, ask for HOOVER part No. 48416013. For the Conquest 18, ask for HOOVER part No. 48416017. If agitator does not rotate, the V-belt is not positioned properly in the groove of the idler pulley.
• calling 1-800-944-9200 for an automated referral of authorized service outlet locations (U.S. only). Do not send your cleaner to Hoover in Glenwillow, Ohio for service, this will only result in delay. If further assistance is needed, contact the Hoover Consumer Response Center, 1-800-263-6376,...
Manual del Propietario Instrucciones de Funcionamiento y Servicio www.hoover.com Repase por favor este manual antes de funcionar su aplicación de Hoover ® Esta aspiradora cumple con los requisitos de la Ley de seguridad y salud ocupacional (Occupational Safety and Health Act, OSHA; Título 29 Sección 1910 Inciso S del Código Federal de Reglamentaciones [Code of Federal Regulations, CFR]).
Si necesita ayuda: Visite nuestro sitio web en hoover.com. Siga el enlace del centro de servicio para encontrar el centro de servicio más cercano o llame al 1-800-944-9200 para que le indiquen de manera automática la ubicación de los centros autorizados de servicio (únicamente en los EE.
Hoover o el Concesionario autorizado de servicio de garantía de Hoover (Depot) • No use este aparato en lugares al aire libre ni en superficies húmedas.
Manguito del rodillo agitador: Qué comprar térmico se reajusta automáticamente, y es posible continuar pasando la aspiradora. Utilice únicamente manguitos del rodillo agitador HOOVER genuinas con su aspiradora. Si el protector térmico sigue activándose después de efectuar los pasos anteriores, es posible que su solicite la pieza n°...
Al comprar una nueva correa Vuelva a colocar la cubierta y la placa inferior. plana, solicite la pieza n° 38528036 de HOOVER. Al Vuelva a colocar la cubierta y los tornillos de la comprar una nueva correa en V, solicite la pieza n°...
Bolsa desechable de papel opcional Cuándo vaciarlo Es posible usar una bolsa desechable de papel tipo A de HOOVER® con la aspiradora en lugar de una Desconecte la aspiradora de la toma de corriente eléctrica antes de revisar o reemplazar la correa.
Need help?
Do you have a question about the HVRC1800010 and is the answer not in the manual?
Questions and answers