Command Center Wall Installation - Majestic 400DVB Installation Instructions Manual

sIGNAtuRe coMMAND - electRIcAl INstAllAtIoN
electrical connections should only be
performed by a qualified, licensed electrician.
Main power supply must be turned off before
connecting fans to the main electrical power
supply or performing service.
Before installing the blower, turn off the
fireplace and allow to cool. only a qualified
service person should service and repair the
fireplace. A qualified service person should
connect and disconnect the fireplace to gas
supply. Follow all local codes.

coMMAND ceNteR WAll INstAllAtIoN

The command center may be mounted on the wall with the use of the SCSWEK Kit (15ft. cable,
junction box, wall cover).
Mount the junction box provided at the desired location on the wall. Do not extend beyond the 15 ft.
wire cable provided.
Route the wire from junction box to lower control area at bottom of fireplace. Unplug the 12" cable
from control box and command center. Plug the 15 ft. extension cable into the control box. Remove
command center from the fireplace and plug the other end of the extension cable into the command
center. Snap on wall cover provided and screw to junction box.
54D0701
TO JUNCTION BOX
IN FIREPLACE
OPTIONAL
{
LIGHT WHITE
BLACK
{
OPTIONAL WHITE
BLOWER BLACK
{ BLACK
OPTIONAL
WHITE
AUX
INPUT 300 WATT MAX EACH
Figure 52 -
Signature Command Wiring Diagram
OPTIONAL
AC BOX
GREEN
CONNECTOR
PIN TO CONTROL BOX
CONTROL BOX
CONVERSION
NG/LP
PLUG IN CONNECTOR
STEPPER MOTOR TO
CONTROL BOX
GROUND
DC POWER/GREEN
PLUG IN CONNECTOR
CONTROL BOX TO
SOLENOID
GAS IN
DVB Series Direct Vent Gas Fireplace
RF RECEIVER
ON/OFF BUTTON
BLACK/THERMOPILE
RED/THERMOPILE
SENSING
IGNITER/SPARKER
PLUG IN CONNECTOR
CONTROL BOX TO COMMAND CENTER
OFF/LO
MASTER
ON/HI
SWTICH
LED
4-AA BATTERY
COMPARTMENT
COMMAND
CENTER
GAS OUT
PILOT GAS TUBING
VALVE
PILOT
39