Signature Command; Command Center Wall Installation - Majestic 500DVKHL Installation And Operating Instructions Manual

SIGnature cOMManD OptIOnaL waLL cOMManD center and BLOwer SySteM
TO JUNCTION BOX
IN FIREPLACE
BACK
LIGHT
OPTIONAL {
BLOWER
Figure 41 -
Signature Command Wiring Diagram
Electrical connections should only be
performed by a qualified, licensed electri-
cian. Main power supply must be turned
off before connecting fans to the main
electrical power supply or performing
service.
Before installing the blower, turn off the
fireplace and allow to cool. Only a quali-
fied service person should service and
repair the fireplace. A qualified service
person should connect and disconnect
the fireplace to gas supply. Follow all
local codes.

cOMManD center waLL InStaLLatIOn

The Command Center may be mounted on the wall with the use of the SCSWEK Kit. (15' cable,
junction box and wall cover).
Mount the junction box provided at the desired location on the wall. Do not extend beyond the
15' wire cable provided.
Route wire from junction box to lower control area at bottom of fireplace. Unplug the 12' cable
from control box and command center. Plug the 15' extension cable into the control box. Re-
move command center from the fireplace and plug the other end of the extension cable into the
command center. Snap on wall cover provided and screw to junction box.
73D0129
WHITE
BLACK
WHITE
BLACK
BLACK
WHITE
GREEN
REAR BURNER
SOLENOID
INPUT 300 WATT MAX EACH
fp2140
Signature command wiring
AC BOX
CONNECTOR
PIN TO CONTROL BOX
CONTROL BOX
CONVERSION
NG/LP
PLUG IN CONNECTOR
CONTROL BOX TO COMMAND CENTER
PLUG IN CONNECTOR
STEPPER MOTOR TO
CONTROL BOX
GROUND
DC POWER/GREEN
PLUG IN CONNECTOR
CONTROL BOX TO
SOLENOID
GAS IN
VALVE
DVKHL Series Gas Fireplace
PILOT
RF RECEIVER
ON/OFF BUTTON
BLACK/THERMOPILE
RED/THERMOPILE
SENSING
IGNITER/SPARKER
OFF/LO
MASTER
ON/HI
SWTICH
LED
4-AA BATTERY
COMPARTMENT
COMMAND
CENTER
GAS OUT
PILOT GAS TUBING
31