Table of Contents
Advertisement
2.7
Cable Connection
Connect the signal cable and power cable as follows.
@ Confirm that the power switches of the image scanner and host computer have
been set to OFF.
@ Connect the image scanner to the host computer with signal cables V and R.
Rear of
To host computer
Figure 2.6
Signal cable connection
Insert the two cables as shown in Figure 3.3. Fasten the two catches to signal cable
V and fix signal cable R with the screws.
The other end of each cable should be attached to the host computer in the same
way.
50FH6020E-01
2-11
Advertisement
Table of Contents
