Download Print this page

Martin Audio C10.1C User Manual page 7

Full-range 10” ceiling loudspeakers


The subwoofer grille may be positioned so that it visually replaces a
ceiling tile in a suspended ceiling but, we repeat - the subwoofer
must not rely on the suspended ceiling structure for its support.
Hint: It is easier to install your CS10 above a suspended ceiling
structure if you temporarily remove surrounding ceiling tiles for better
access and light.
We must repeat; threaded rods or eyebolts must be
permanently attached to the brackets provided using aircraft
style locking nuts so that they cannot loosen under vibration.
Do not simply hang this product from "hooks" as it could
escape from them when driven with low frequency signals at
high volume.
If height adjustment is required, we recommend that you use locking
adjustment nuts either side of the three brackets or turnbuckles
(200Kg rating) between the building structure and the CS10
Anti-vibration gasket strip (supplied) may be placed around the edge
of the grille for a snug fit without vibration.
Amplifier power input is via a 4-pin rising clamp plug providing
+ and – Inputs and + and – Loop Through connections.
The CS10 input and loop connector must be fireproofed using the
steel cover and screws provided. This cover has a 19mm (0.75")
knockout and a clamped cable entry.
All material © 2007. Martin Audio Ltd. Subject to change without notice.



Subscribe to Our Youtube Channel

This manual is also suitable for: