Rspi Card (Optional); Removing The Rspi Card - Dell PowerEdge M830 Owner's Manual

3. Remove the IDSDM card.
CAUTION: To prevent damage to the IDSDM card, hold the card only by its edges.
NOTE: You must remove the IDSDM card to replace a faulty IDSDM card or service other
components inside the system.
Steps
1. Align the following:
• The slot on the card edge with the projection tabs on the PCIe mezzanine card support.
• The two screw holes on the IDSDM card with the standoffs on the system board.
• The hole on the SD card slot bracket with the screw hole on the IDSDM card.
2. Install the two screws to secure the SD card slot bracket and IDSDM card to the system board.
Next steps
1. If applicable, install the SD card(s) and the internal USB key.
2. Install the PCIe mezzanine card.
3. Follow the procedure listed in
Related Links
Replacing an SD card
Replacing the internal USB key
Removing a PCIe mezzanine card
Removing the IDSDM card

rSPI card (optional)

rSPI (restore Serial Peripheral Interface) is a SPI flash device to store information about the system Service
Tag, system configuration, or iDRAC license.

Removing the rSPI card

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: You must remove the rSPI card to replace a faulty rSPI card or service other components
inside the system.
1. Ensure that you read the
2. Follow the procedure listed in
3. Keep the #2 Phillips screwdriver ready.
4. Remove the PCIe mezzanine card.
Steps
1. Remove the two screws securing the rSPI card to the system board.
After working inside your
Safety instructions.
Before working inside your
system.
system.
65