Table of Contents
Advertisement
For the installer
Building in the oven
All our ovens are designed for being easily built in - whether masonry or a cabinet
made of wood laminated plastic or metal, provided it is heat resistant.
To fit the oven properly, any such enclosure, should be as shown in figures 8 and 9.
The oven should then be secured by 4 screws fitted into the holes provided at the
sides of the oven.
Oven installation
The oven can be installed either into a tall housing unit or built under the working
surface into a kitchen base unit. The unit should have an aperture according to the
measurements as detailed in figures 8 and 9.
Warning!
The installer should note that the appliance is of type "X" and that the temperature rise
of the walls surrounding the oven shall not exceed 75 K.
We would point out that the adhesive which unites the plastic laminate to the furniture
must withstand temperature not less than 150°C to avoid delamination.
figure 8
figure 9
11
Advertisement
Table of Contents
