Inter-m LM-6414 Operation Manual page 7

7. PE K INDIC TORS
These LED indicators light when the input signal to the associated channel is 3dB below clipping. If the
indicator is lit steadily, reduce the channel's Trim level (8) to avoid distortion.
8. CH NNEL TRIM (G IN) CONTROLS
These knobs control the input level for the associated input channel.
9. EQ ND UX SEND CONTROLS
These knobs control the equalization for the associated input channel. Three bands of equalization are
provided:
Low: 100Hz, ±15dB, Shelving type
Mid: 1kHz, ±15dB, Shelving type
High: 10kHz ±15dB, Shelving type
Below the EQ Controls are ux 1 and ux 2 Send Controls. These knobs control the amount of signal sent to
the ux busses.
10. P N CONTROLS
These knobs control the L/R balance position for the associated input channel. Depending on which output
sources are selected with the channel's ssign Switches (5), the Pan Controls will adjust the signal between
Left and Right on the stereo bus, and/or between Bus 1/3 and 2/4 on the Output busses 1-4
If the knob is rotated to the center, the channel's signal will be sent equally to the stereo Left and Right, Bus
1/2 and Bus 3/4 outputs.
If the knob is rotated fully counter-clockwise (to the left), the channel's signal will be sent only to the s tereo
Left, Bus 1 and Bus 3 outputs.
If the knob is rotated fully clockwise (to the right), the channel's signal will be sent only to the stereo Right,
Bus 2 and Bus 4 outputs.
11. PFL SWITCHES
These buttons are used to monitor each channel's output status via the headphone jack.
When monitoring the channel's input signal, PFL position allows you to hear the input at a level unaffected
by the position of the channel's Output, FX Send and Pan settings. FL position will allow you to hear the
input as it appears in the final mix, with Output, FX Send and Pan settings as selected for the channel.
12. CH NNEL OUTPUT LEVELS
These knobs control the output level (the level sent to the output bus) for the associated input channel. Levels
of unused channels should be set to the minimum setting.
13. BUS 1 ND 3 M STER F DERS
These faders adjust the output level of signals routed to Bus 1 and Bus 3.
14. BUS 2 ND 4 M STER F DERS
These faders adjust the output level of signals routed to Bus 2 and Bus 4.
15. STEREO M STER F DER
This fader adjusts the output level of signals routed to the Master Bus.
MIC LINE MIXER
5
LM-6414