Table of Contents
Advertisement
Use the Up or Down arrow button to select the number of drives. If
you selected Level 5 in step 4, select "3". Level 5 requires at least 3
drives to perform a RAID array.
Note:
It would be best if you have more than 3 drives in-
stalled. This will serve as a backup drive in case a
drive becomes defective.
6. You will be asked to confirm your settings.
Use the arrow key to select "Yes" and press "SEL".
7. The controller will now restart and initialize in order for the settings
to become effective.
8. After the subsystem completes initialization, the screen will appear as
shown below.
9. The drives that are RAID READY will be mapped to the host
channel. Select View Config under the Main Menu to check whether
the host channels are detected by the Host system. This is to ensure
that the SCSI card in the Host subsystem is able to access the hard
drives.
Press ESC to return to the Main Menu.
211 Disk Num 3
NO
Initial(2)
RAID READY
INIT OK !
RAID READY
1%
Advertisement
Table of Contents
