Table of Contents
Advertisement
Warning:
We strongly recommend that only experienced user
should reset the subsystem.
For a Quick Setup of the Subsystem:
1. Use the Up or Down arrow button to view the configuration of your
subsystem such as the firmware version, memory size, hard drives
installed, serial number, etc.
2. Press the "Sel" button to enter the Main Menu. The screen will
appear as shown below. (Edit Chasis is the first field in the Main
Menu)
3. Press the Down arrow button once to go to the Quick Setup menu.
4. Press the "Sel" button to enter Quick Setup.
Use the Up or Down arrow button to select a RAID Level – Level 0,
Level 1, Level 0+1, Level 3 or Level 5 and press "Sel". We recom-
mend that you select Level 5 which is faster and safer. Refer to
Appendix A for descriptions of the RAID levels.
5. Press "SEL" to enter the Disk Num menu. This will allow you to
select the number of drives to perform a RAID array.
Main Menu
1 Edit Chasis
Main Menu
2 Quick Setup
2 Quick Setup
21 Level5
21 Level5
211 Disk Num 3
Advertisement
Table of Contents
