Table of Contents
Advertisement
This Quick Setup Guide is intended as a shortcut so that experienced
users can get their RAID Disk Array subsystem started as quickly as
possible. If this is your first time to configure the subsystem, the screen
on the Disk Array Controller will show the following message.
Before configuring the subsystem, make sure the controller is able to
detect all the hard drives installed in your subsystem. This is to ensure
that the mobile racks and hard drives are functioning normally. Press the
Down arrow button until you see "S1". "S1" refers to the first slot. If
there is a drive installed in slot 1, the following will appear on the
screen:
"S1" - "S" refers to slot and "1" refers to the location of the slot where
the drive is installed. Your subsystem comes with 8 slots but S4 is
default configured as "Not Installed". Please refer to page 5.
"1:0" - "1" denotes the device channel where the drive is connected.
(Refer to section 3.2 for more information.) "0" refers to the SCSI ID of
the drive. The SCSI ID of each slot has already been preset. DO NOT
change the SCSI ID of your drive.
" " moving up and down at the lower right corner of the screen
indicates that the controller is functioning normally. The " " becomes
"zZ" if the host is accessing the subsystem. It becomes "wW" when
memory is writing cache to your hard drive. If it is not moving, some-
thing must be wrong with the controller. Use a paper clip or pin to press
the Reset button located above the Up arrow button.
Refer to section 1.4.1 for the locations and functions of the up and
down arrow buttons, SEL button and ESC button.
RAID-800S
NO RAID
S1: (Brand) (Model)
1:0 (Capacity)
Advertisement
Table of Contents
