Panel Function Instruction - zika MIG 200G Owner's Manual

PANEL FUNCTION INSTRUCTION

1. Change-over switch
1） Welding diameter change-over switch: When welding wires of different diameter are used, the switch shall be in
the corresponding position correctly.
2） ARC/MIG changeover switch: change the welding station from ARC to MIG by turning the switch.
2. Adjusting knob
1） Welding voltage adjustment: this knob is used to adjust the output voltage.
2） Welding current adjustment: this knob is used to adjust the output current.
3） Arc trait adjustment: The softness and hardness level of the electric arc can be adjusted to achieve best welding
effect. When the current is small, the electric arc shall be hard to reduce arc interruption. When large current, the
electric arc shall be soft so as to reduce splatter.
OWNER'S MANUAL
- 7 - YF-20M A0