Four Sided Faceplate Installation - Montigo 30FID Installation & Maintenance Manual

Four Sided Faceplate Installation

The Faceplate Surround has two main parts: the Rear Panel
and the Front Panel. The Rear Panel has a master override
switch installed on the upper right corner. The Rear Panel
has to be installed prior to the Front Panel.
Found behind
panel
Brackets
supplied
Figure 23 Sec.7 Four Sided Faceplate Kit Contents
1). Remove the Lighting Instructions from the Control area
and leave on the floor in front of the unit.
Figure 24 Sec.7
2). Install the Rear Faceplate Panel support brackets using screws
provided (4 locations). Ensure proper orientation of the bracket.
Figure 25 Sec.7
XG0523-150909
Installation
Screws
supplied
Figure 26 Sec.7
3) Hold the Rear Faceplate in place.
Figure 27 Sec.7
4) Temporarily, place the Electrical Cord through the hole in the
bottom right corner of the Rear Faceplate
Figure 28 Sec.7
I-Series Indoor Gas Fireplace
Page 29