TechniSat HDTV 32 Plus Operating Manual page 26

Antenna signals (DVB-S)
Here, select the number of DVB-S antenna connections you have made to the TV set.
(If the source is DVB-S, as described in the "Selection of the received signals" sec-
tion, and deactivated, instead of this page, the installation assistant goes directly to the page
"Antenna settings (DVB-T)".)
Use the right/left arrow keys to mark whether you have connected one or two
>
antenna signals.
Use the green function key to confirm your selection and proceed to the "antenna
>
configuration (DVB-S)".
5
Antenna configuration (DVB-S)
In this installation step, you can configure the setting of your device to the congifuration of
your satellite antenna.
(If the source is DVB-S-, as described in the "Selection of the received signals" sec-
tion is deactivated, instead of this page, the installation assistant goes directly to the page
"Antenna settings (DVB-T)".)
If you wish to confirm the standard antenna setting press the green function key
>
to confirm.
In this case proceed from the point "Antenna settings (DVB-T)".
> If the configuration of your reception installation does not conform to the standard
setting, press the yellow function key Change.
The settable antenna configurations now appear, which can be adjusted to suit your
receiving equipment in accordance with Point 8.5 "Antenna settings (DVB-S)".
Once you have reached the desired configuration, press the green function key
>
Confirm.
A display of the satellites now set appears on the display for verification.
To confirm the setting, press the green function key or to cancel, press the yel-
>
low function key Modify.
Antenna settings (DVB-T)
If you use an active DVB-T antenna, which lacks its own power supply or where you do not
wish to use this latter, the amplifier of the active antenna can be powered via your TV set
using the coaxial cable. Set the Antenna feeder to on in this case.
In addition, a channel spectrum with the signal levels of the channels is also displayed in
this step. Using this spectrum you can set up your DVB-T antenna for optimal reception.
(If the source is DVB-T as described in the "Selection of the received signals" sec-
tion, and deactivated, instead of this page the installation assistant goes directly to the page
"Search station".)
Using the right/left arrow keys, you may switch the power supply on or off.
>
Confirm the setting by pressing the green function key Confirm.
>
26