Advertisement
Final Assembly
First, place fan head assembly onto the upper pole, lining
up the fan post screw with the hole in the extension pole.
Then, simply insert the fan post screw into the hole and
tighten until a secure fit is obtained. Lastly, insert the tilt
adjustment knob into the neck joint and tighten in place.
NOTE: If your fan does not have a screw hole in the
extension pole but instead has an indentation around the
top of the pole; please do the following:
STEP 1: First, place the fan head assembly onto the
upper pole and tighten the fan post screw until
a secure fit is obtained.
STEP 2: Insert the tilt adjustment knob into the neck
joint and tighten in place.
OPERATING INSTRUCTIONS
1. Set fan base on a dry, level surface.
2. Please make sure the Speed Control Knob is in the
off position. The Speed Control Knob is located on the
top of the Fan Motor Housing.
3. Plug cord into any standard 120 volt AC outlet.
4. The Speed is adjusted by turning the control knob to
the desired setting, Off-High-Medium-Low (O-3-2-1).
5. The oscillation Control Knob is located on the top of the
Fan Motor Housing. To Start Oscillation, push Control
Knob down. To Stop Oscillation, pull Control Knob up.
FEATU RE S - O P ER AT I O N S
ADJUSTMENT INSTRUCTIONS
Tilt Adjustment
Follow these instructions to tilt the Fan Head for upward
angle air movement.
STEP 1: To change the tilting angle of the fan head;
simply loosen the Tilt Adjustment Knob (see
Figure 3).
STEP 2: Move the fan head to the desired angle, and
firmly tighten the knob to lock in place.
Height Adjustment
Follow these instructions to adjust the height of the fan.
STEP 1: Turn the height adjustment collar counter-
clockwise to loosen pole.
STEP 2: Adjust the extension pole to the desired height,
and firmly tighten the height adjustment collar
in a clockwise direction.
Figure 3
C
D
A B
A. Logo Plate
B. Front Grill
C. Fan Blade Cap
D. Fan Blade
E. Rear-Grill Mounting
Ring
F. Rear Grill
G. Motor Shaft
H. Speed Control Knob
I. Oscillation Knob
J. Motor Housing
G H I
F
E
P
K. Neck
L. Tilt-Adjustment Knob
M. Upper Pole
N. Height Adjustment
Collar
O. Lower Pole
P. Extension Legs
Q. Fan Post Screw
J
K
L
Q
M
N
O
Advertisement
