Page 1
Sunbeam Remote Controlled Tower Fan Instruction Booklet FA7200 90cm Remote Controlled Tower Fan Please read these instructions carefully and retain for future reference.
Contents Sunbeam’s Safety Precautions Safety Precautions For Your Tower Fan Locating Your Tower Fan Features Of Your Sunbeam Tower Fan Assembling Your Tower Fan Using Your Tower Fan Troubleshooting Guide Care And Cleaning...
Young children should be supervised to ensure that they do not play with the appliance. If you have any concerns regarding the performance and use of your appliance, please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line. Ensure the above safety precautions are understood.
Important Instructions - Retain For Future Use If you have any concerns regarding the performance and use of your appliance, please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line. Ensure the above safety precautions are understood.
Locating Your Tower Fan Always locate your fan on a fl at level surface. Your tower fan should be located in a dry, cool, well ventilated location. Keep your fan away from heat sources, corrosive gases and avoid direct sunlight. Do not attempt to move your tower fan whilst it is operating.
Features Of Your Sunbeam Tower Fan Remote control storage When not in use, store your remote control in the handy storage compartment on the rear of the fan body. Carry handle Convenient carry handle allows you to easily carry your fan from room to room.
Page 7
Remote control Adjust the fan setting, auto off or oscillation from anywhere in the room using the full function remote control. Auto Off button Fan speed button The auto off timer allows Choose from 3 speed you to set your tower fan to settings, low medium turn off after either 1, 2, 4 or high.
Assembling Your Tower Fan Remove the screws from beneath the tower Join the two halves of the base together Using a phillips head screwdriver, remove the Feed the cord between the two halves of the 4 screws from underneath the tower. base.
Page 9
Assembling Your Tower Fan (continued) Lower the tower onto the base Screw the tower to the base Align the tower and the base as shown. Use the 4 screws you put aside earlier to secure the tower to the base. Push the tower down onto the base until it is fi...
Switching the fan on Selecting a fan speed setting Place the fan on a fl at level surface. Your Sunbeam tower fan has 3 speed settings as follows: Insert the plug into a 230/240V power outlet and turn the power on.
Page 11
Using Your Tower Fan (continued) Using the remote control Changing the batteries Remove the remote control from its compart- Slide the rear cover off the remote control ment at the rear of the tower as shown. unit. Point the remote towards the control panel Replace the spent batteries with 2 fresh AAA on the front of the tower to operate.
Page 12
Using Your Tower Fan (continued) Using the oscillation function Using the auto off timer The 70 degree oscillation function can be The auto off timer automatically switches the used on any setting. fan off after a preset number of hours. Turn the unit on and select any fan speed.
Page 13
Using Your Tower Fan (continued) Nature mode Sleep mode Nature mode provides an extra level of Sleep mode is identical to Nature mode with comfort by simulating the natural rise and fall the added advantage that the highest fan of the wind over time. You can use this mode speed gradually decreases over time.
Troubleshooting Guide If your tower fan fails to operate check the If your remote control fails to operate check following: the following: • Make sure the electrical outlet or circuit • Ensure that you point the remote towards the breaker is working. front of the fan.
Page 15
Should you experience any diffi culties Sunbeam Service Centres with your appliance, please phone our Sunbeam has established a network of free call customer service line for advice authorised service centres throughout on 1300 881 861 in Australia, or 0800 Australia and New Zealand to provide 786 232 in New Zealand.