Advertisement
PRE-INSTALLATION INSTRUCTIONS
NOTE: MAKE SURE YOU REMOVE ALL CONTENTS FROM
THE PACKAGE. PLEASE CHECK PACKAGING MATERIALS FOR
PARTS THAT COULD BE REQUIRED TO OPERATE YOUR FAN.
• The window fan comes fully assembled and is ready
for immediate installation.
• Before installation, familiarize yourself with the
built-in 7 inch (17cm) extender on the right side of
the fan and the additional 3.5 inch (9cm) extender
which attaches to the left side of the fan housing (see
Figure 1). The extra extender is packed in styrofoam
at end of the box.
This window fan has been designed to fit double-hung
windows with minimum openings of 22 inches (55cm)
wide and 10 inches (25cm) high.
FIGURE 1
A
B
A. 3.5 inch (9cm) Slide
on Extender
B. Top Window Support
C. 2 Speed Motor Control
WINDOW FAN INSTALLATION
NOTE: WE RECOMMEND KEEPING YOUR WINDOW
SCREEN IN PLACE.
1. Align the Window Fan horizontally in the window with
the controls facing you and the Built-In Extender
Panel to the right.
2. With the window open take an accurate measurement
of the opening where the unit will be placed.
3. Match your window measurement with the
INSTALLATION GUIDE.
4. Once you have attached the extender panel(s) (if
needed), set the fan in the window. You will complete
installation with built-in extender. Pull out both clips
FE ATU RE S - O P E R AT I O N S
C
D. Built-in Adjustable
Extender Panel (pulls
out 7 inch/17cm )
on right side of the fan then pull out the built-in
extender. To lock extender into place, push the clips
down.
5. Carefully close the window onto the top of the fan so
that the bottom edge of the window rests behind top
line of fan housing. This helps keep the fan in place.
For slider windows (will fit windows 10
inches/25cm and 36 inches/91cm high)
In a slider window, the control must face inward, towards
the window. The 7 inch (17cm) built-in extender will be
positioned on top. Prior to installing unit in window,
measure the height and adjust the upper extender for a
snug fit.
NOTE: In some slider windows you may need to remove
the screen.
FIGURE 2
D
LEFT
3.5 inch (9cm)
extender panel
INSTALLATION GUIDE
For 22 inches (55cm) to 29 inches (73cm) :
Use up to 7 inch (17cm) of right side, pull out extender
panel.
For 29 inches (73cm) to 33.25 inches (83cm) :
Use one 3.5 inch (9cm) extender panel on the left side.
Adjust the pull out extender on the right side for a tight
fit (from 0.5 inch (1cm) to 7 inch (17cm) ).
Larger than 33.25 inches (83cm) :
Additional extender panels will be required (See Window
Fan Accessory Section).
FRONT VIEW
RIGHT
Built-in extender, pulls out
up to 7 inch (17cm)
22 inches (55cm)
UNIT'S LENGTH
Advertisement
