Related Manuals for Sunbeam FA7500
Summary of Contents for Sunbeam FA7500
- Page 1 Sunbeam Brushed Remote Control Tower Fan Instruction Booklet FA7500 120cm Brushed Remote Control Tower Fan Please read these instructions carefully and retain for future reference.
-
Page 2: Table Of Contents
Contents Sunbeam’s Safety Precautions Safety Precautions For Your Tower Fan Locating Your Tower Fan Features Of Your Sunbeam Tower Fan Assembling Your Tower Fan Using Your Tower Fan Troubleshooting Guide Care And Cleaning... -
Page 3: Sunbeam's Safety Precautions
Do not immerse the appliance in water or any responsible for their safety. other liquid. If you have any concerns regarding the performance and use of your appliance, please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line. Ensure the above safety precautions are understood. -
Page 4: Safety Precautions For Your Tower Fan
Important Instructions - Retain For Future Use If you have any concerns regarding the performance and use of your appliance, please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line. Ensure the above safety precautions are understood. -
Page 5: Locating Your Tower Fan
Locating Your Tower Fan Always locate your fan on a fl at level surface. Your tower fan should be located in a dry, cool, well ventilated location. Keep your fan away from heat sources, corrosive gases and avoid direct sunlight. Do not attempt to move your tower fan whilst it is operating. -
Page 6: Features Of Your Sunbeam Tower Fan
Features Of Your Sunbeam Tower Fan Remote control storage When not in use, store your remote control in the handy storage compartment on the rear of the fan body. Carry handle Convenient carry handle allows you to easily carry your fan from room to room. - Page 7 Remote control Adjust the fan setting, auto off or oscillation from anywhere in the room using the full function remote control. Fan speed button Auto Off button Choose from 3 speed The auto off timer settings, low medium allows you to set or high.
-
Page 8: Assembling Your Tower Fan
Assembling Your Tower Fan Remove the screws from beneath the tower Lower the tower onto the base Using a phillips head screwdriver, remove the Feed the cord through the hole in the centre 6 screws from underneath the tower. of the base. Put the screws aside. - Page 9 Assembling Your Tower Fan (continued) Screw the tower to the base Clip the cord into place Use the 6 screws you put aside earlier to Feed the cord along the channel underneath secure the tower to the base. the base. Screw the cord into the edge of the base using the two screws provided.
-
Page 10: Using Your Tower Fan
Switching the fan on Selecting a fan speed setting Place the fan on a fl at level surface. Your Sunbeam tower fan has 3 speed settings as follows: Insert the plug into a 230/240V power outlet and turn the power on. - Page 11 Using Your Tower Fan (continued) Using the remote control Changing the batteries Remove the remote control from its compart- Slide the rear cover off the remote control ment at the rear of the tower as shown. unit. Point the remote towards the control panel Replace the spent batteries with 2 fresh on the front of the tower to operate.
- Page 12 Using Your Tower Fan (continued) Using the auto off timer Using the oscillation function The auto off timer automatically switches the The 70 degree oscillation function can be fan off after a preset number of hours. used on any setting. Turn the unit on and select any fan speed.
- Page 13 Using Your Tower Fan (continued) Nature mode Nature mode provides an extra level of comfort by simulating the natural rise and fall of the wind over time. You can use this mode on any fan speed setting. To use Nature mode: Choose a fan speed.
-
Page 14: Troubleshooting Guide
Troubleshooting Guide If your tower fan fails to operate check the If your remote control fails to operate check following: the following: • Make sure the electrical outlet or circuit • Ensure that you point the remote towards the breaker is working. front of the fan. - Page 15 Should you experience any diffi culties Sunbeam Service Centres with your appliance, please phone our Sunbeam has established a network of free call customer service line for advice authorised service centres throughout on 1300 881 861 in Australia, or 0800 Australia and New Zealand to provide 786 232 in New Zealand.
- Page 16 Due to minor changes in design or otherwise, the product may differ from the one shown in this leafl et. © Copyright Sunbeam Corporation Limited 2008. ABN 45 000 006 771 0708 Sunbeam Corporation is a division of GUD Holdings Ltd.