Advertisement
ASSEMBLY INSTRUCTIONS
Base Assembly (See Figure 1)
You will need the base and four extension legs.
Push in the small tab located on the bottom of each
extension leg and snap into base.
Figure 1
Pole Assembly (See Figure 2)
STEP 1: Remove the height
adjustment collar
from the base by
turning counter
clockwise.
STEP 2: Take the pole
assembly, with the
solid end down, and
insert it into the
base. The hollow end
of the pole will be
facing up.
STEP 3: Replace the height
adjustment collar
over the pole
assembly, slide it
down the pole, and
secure it to the base
by turning clockwise ( Refer to Figure 2 ).
FE ATU RE S - O P E R AT I O N S
g
Figure 2
Fan Head Assembly (See Figure 4 - 6)
STEP 1: Position the rear
grill over the motor
shaft, making
certain the 2
notches at the top
and bottom of the
rear grill fit over
the 2 prongs on the
motor housing.
Please make sure
the rear grill fits
securely against the
motor housing
( Refer to Figure 4 ).
STEP 2: Secure the rear grill
in its place using
the rear grill
mounting-ring. Turn
this ring clockwise
and tighten firmly
( Refer to Figure 5 ).
STEP 3: Slide the fan blade;
with the hollowed
interior of the
blade facing
towards the rear
grill firmly onto the
motor shaft. Make sure the shaft protrudes from
the front of the blade ( Refer to Figure 6 ).
STEP 4: Secure the fan blade onto the motor shaft by
turning the fan blade cap in a counter-clockwise
direction until it is firmly in place ( Refer to
Figure 6 ).
STEP 5: Prepare the front grill by simply snapping the
circular front grill logo plate in place.
STEP 6: Center the front grill by aligning the Sunbeam
logo so it is horizontal and parallel to the floor.
Then secure the front and rear grills completely
together by snapping into place. Lastly, tighten
the securing screw at the bottom of the rear grill.
Figure 4
Figure 5
Figure 6
TM
Advertisement
