Page 1
Sunbeam Pedestal Fan with Remote Control Instruction Booklet FA8600 40cm Pedestal Fan Please read these instructions carefully and retain for future reference.
• Never leave an appliance unattended while in use. If you have any concerns regarding the performance and use of your appliance, please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line. Ensure the above safety precautions are understood.
Safety Precautions For Your Pedestal Fan • Do not use outdoors. • The fan must not be used if the guards are damaged in any way. • Do not run the cord of the fan under carpeting. Do not cover the cord with throw •...
Locating Your Pedestal Fan 1.Always locate your fan on a level surface. 2.Your pedestal fan should be located in a dry, cool, well ventilated location. Keep your fan away from heat sources, corrosive gases and avoid direct sunlight. 3.Do not attempt to move your pedestal fan whilst it is operating.
Page 5
Features Of Your Sunbeam Pedestal Fan Metal Grille Easily assembled, 50cm secure grille. Plastic Fan Blades 3 blades to effectively move the air about your room. Control Panel Simply press the on/off button to turn the unit on. Use the other buttons to select wind mode, timer, speed and oscillation functions.
2.Unfasten the interlocking nut and blade appears on the inside of the grill), the knob from the front of the motor Sunbeam logo should be straight. Push the (See Figure 2) and place to one side. round edges of the grill firmly together with the back grill and lock the clip.
Page 8
Assembling Your Pedestal Fan (continued) Connecting The Stand base, extension shaft, 3.Insert the upper shaft into the extension upper shaft and base locking nut shaft and secure with the rear stand. Screw using a flat head screw driver. 1.Locate the base locking nut. 2.Insert the lower extension shaft firmly into the base and attach the moulded securing knob to the underside of the base and...
Remote Control Remote control Oscillation Operates within 8 metres of the Your pedestal fan oscillates 70°, Pedestal Fan. distributing cool air throughout the room. Fan speed button Choose from 3 speed settings, Preset/Timer low medium or high. The preset timer allows you to set your pedestal fan to turn Wind Mode off after 1, 2 or 4 hours.
Using Your Pedestal Fan Selecting a fan speed 1. Place the pedestal fan on a flat level surface 2. Adjust the height by unlocking the height 1. To select a fan speed simply press the adjustment clip on the lower shaft. Raise the ‘speed’...
Page 11
Using Your Pedestal Fan (continued) Oscillation Timer Press the oscillation button to turn on. Pre-set to turn off To pre-set the timer to turn the fan off, press To turn oscillation off, press the oscillation the timer button to switch to timer mode. Press button again.
Page 12
Using Your Pedestal Fan (continued) Operations 1. ON/OFF Press this symbol to control the fan power on or off. Touch one time, fan shows power on, for one more time, the fan is power off. 2. Wind Speed Press this symbol to control the wind speed.
Care and Cleaning • Ensure that your pedestal fan is switched • Take care that excessive dust does not build off and disconnected from the power outlet up in or around the motor body. Use a dry before cleaning. soft brush or vacuum cleaner to remove it. •...
2 Year Warranty This Sunbeam product is covered by a 2 year replacement or repair warranty, which is in addition to your rights under the Australian Consumer Law (if your product was purchased in Australia) or New Zealand Consumer Guarantees Act (if your product was purchased in New Zealand).
Page 15
Sunbeam Corporation Limited 2012. ABN 45 000 006 771 Units 5 & 6, 13 Lord Street Botany NSW 2019 Australia Unit 3, Building D 26 Vestey Drive Mt Wellington Auckland New Zealand 6/13 Sunbeam Corporation is a division of GUD Holdings Ltd.
Need help?
Do you have a question about the FA8600 and is the answer not in the manual?
Questions and answers