Installing Non-Combustible Facing Material - Heatilator CRAVE4836 Installation Manual

C. Installing Non-Combustible Facing Material
WARNING! Risk of Fire!
• Follow these instructions exactly.
• Facing materials must be installed properly to prevent
fi re.
• No materials may be substituted without authorization
by Hearth & Home Technologies.
• Remove protective cardboard sleeve from non-
combustible facing pieces, which are included with the
appliance.
• Install non-combustible facing material to the appliance
using the 2 inch screws supplied in the manual bag
assembly. There may be extra screws included.
• Attach top board to the framing members with regular
sheetrock screws or nails. See Figure 6.6.
• Attach left and right side pieces to framing members with
regular sheetrock screws or nails.
• Use a wet or dry towel or soft brush to remove dust or
dirt from facing material.
• See Section 10 for fi nishing materials guidelines.
Figure 6.6 Install Factory-Included Non-Combustible Facing
Material
Heatilator • CRAVE4836/ST, CRAVE6048/ST, CRAVE7260/ST, CRAVE8472/ST Installation Manual • 2301-970 Rev. Q • 9/15
35