Heatilator CRAVE4836 Installation Manual page 50

WALL SHEATHING
NON-COMBUSTIBLE
FINISHING MATERIAL
OVERLAP FIT = 0-1 IN. THICK
INSIDE FIT = 0-4 IN. THICK
TEMPLATE BRACKET
Figure 10.3 Finishing Materials - See-Through Models
Decorative facing material thickness is measured from
the face of the installed non-combustible board. See Fig-
ure 10.2 and Figure 10.3.
The fronts for this appliance are compatible with non-
combustible materials. See Figure 10.2 and Figure 10.3.
Refer to Section 1.E and 1.F of this manual for defi nitions
and qualifi cations of non-combustible and combustible
materials.
Specifi c requirements for each method if installation are
described in this section.
Installation of fi nishing materials can be accomplished by
either the "overlap" or "inside-fi t" method, depending on
what type of decorative front is to be installed. Overlap
fi t decorative fronts include the Four Square and Illusion.
The Clean Face Trim Front (CFT) is an inside fi t decorative
front.
Heatilator • CRAVE4836/ST, CRAVE6048/ST, CRAVE7260/ST, CRAVE8472/ST Installation Manual • 2301-970 Rev. Q • 9/15
50
1/2 IN. THICK
1/2 IN.
INSTALLED
NON-COMBUSTIBLE
BOARD
NON-COMBUSTIBLE
FINISHING MATERIAL
OVERLAP FIT = 0-1 IN. THICK
INSIDE FIT = 0-4 IN. THICK
TEMPLATE BRACKET