Installing Non-Combustible Facing Material - Heatilator CRAVE4836-C Installation Manual

NAILING TABS
BOTH SIDES
Figure 6.8 Proper Positioning and Securing of an Appliance
48 Heatilator • CRAVE4836-C/ST-C, CRAVE6048-C/ST-C, CRAVE7260-C/ST-C, CRAVE8472-C/ST-C Installation Manual • 2601-980 Rev. N • 11/21
D. Installing Non-Combustible Facing Material
WARNING! Risk of Fire!
• Follow these instructions exactly.
• Facing materials must be installed properly to prevent
fire.
• No materials may be substituted without authorization
by Hearth & Home Technologies.
• Remove protective cardboard sleeve from non-
combustible facing pieces, which are included with the
appliance.
• Install non-combustible facing material to the appliance
using the 1-1/4 inch screws supplied in the manual bag
assembly. There may be extra screws included.
• Attach top board to the framing members with regular
sheetrock screws or nails. See Figure 6.9.
• Attach left and right side pieces to framing members with
regular sheetrock screws or nails.
• Use a wet or dry towel or soft brush to remove dust or
dirt from facing material.
• See Section 10 for finishing materials guidelines.
Figure 6.9 Install Factory-Included Non-Combustible Facing
Material