Table of Contents
Advertisement
D. Non-Combustible Material Installation
WARNING! Risk of Fire! DO NOT remove factory-
installed non-combustible material.
This model ships with the required top, left and right non-
combustible board. The top non-combustible board has
been pre-installed at the factory with three screws. The left
and right side non-combustible boards are shipped next to
the non-combustible board inside the cardboard splatter
guard in front of the appliance. See Figure 6.7.
1. Remove the left and right non-combustible components
from the shipping position and set aside.
2. Pivot the lower cover panel down by lifting the lower
cover panel "up" and then rotating the top downward.
3. Locate the manual bag assembly inside the appliance
and remove the small package containing the 1-1/2 inch
Phillips screws.
Note: Care should be taken when installing screws into
the non-combustible board. DO NOT overtighten screws.
Screws should be set "flush" to the surface of the non-
combustible board.
4. Further secure the top non-combustible board by
installing screws into the pilot holes located in the upper
left and right corners of the top non-combustible board
as shown in Figure 6.8.
5. Install the left and right non-combustible components
with four of the provided Phillips screws. See Figure 6.8.
After all non-combustible material has been installed,
remove the small package of sheet metal screws from
the manual bag. Reinstall the lower cover panel. Be
sure to "hook" it onto the appliance. Use two screws
from the package to fasten the top sides of the cover
panel to the appliance. The holes from the cover panel
should align with the holes in the sides of the appliance.
See Figure 6.7.
6. Install drywall screws (not provided) around the
perimeter of the installed non-combustible components
to secure it to the framing material. Refer to Section 10
for more information.
Figure 6.7 Shipping Position - Non-Combustible Sides
and Auxiliary Hanging Brackets
Heatilator • RAVE32-IFT-B, RAVE36-IFT-B, RAVE42-IFT-B Installation Manual • 2619-983 Rev. U • 9/22
E. Auxiliary Hanging Bracket Installation
The left and right auxiliary hanging brackets are shipped
next to the non-combustible board in the cardboard splatter
guard in front of the appliance. See Figure 6.7.
1. Remove the left and right auxiliary hanging brackets
from the shipping position.
2. Bend the brackets as shown in Figure 6.9.
3. Using the shoulder screws included in the manual bag,
attach the auxiliary hanging brackets onto the appliance
as shown in Figure 6.8 using the mounting slots
referenced in Figure 6.9. Pull the brackets away from
the appliance to aid with finishing material installation.
INSTALL TWO OF THE
PROVIDED SCREWS INTO
THESE PILOT HOLES
SCREW LOCATIONS FOR
AUXILIARY HANGING BRACKETS
Figure 6.8 Installation of the Side Non-Combustible
Components
TOP FINISH TABS (X2)
MOUNTING SLOTS
(2 PER BRACKET)
BOTTOM FINISH TABS (X2)
LEFT HAND BRACKET RIGHT HAND BRACKET
Figure 6.9 Auxiliary Hanging Brackets - Bent For Installation
INSTALL FOUR
OF THE PROVIDED
SCREWS INTO
THESE PILOT HOLES
NOTE: BOTH LEFT &
RIGHT SIDES
ARROW MUST
POINT UP
43
Advertisement
Table of Contents
