Install Media - Heatilator CRAVE4836 Installation Manual

D. Install Media
A media kit is included with the CRAVE models. Install
rock media according to these instructions.
WARNING! Choking Hazard! Keep media out of reach
of children.
CAUTION! Risk of Burns! The fi replace should be turned
off and cooled before media is installed.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
Cleaning the Media
During shipment of the media, dust and debris can
accumulate. It is recommended that the media be rinsed
thoroughly with water to remove dust and small particles.
An easy method to clean the media is to place the media
into a pail and rinse thoroughly. Spread the media out
over paper towels and allow the media to dry before
installing them into the fi replace.
INSTALLATION
1. Choose 7 - 10 round pieces of media approximately
1/2 inch in size and set them aside. These will be used
later to conceal the pilot end of the burner. Reference
Figure 1 for choosing round pieces of glass.
WARNING! Risk of Explosion! DO NOT put any fl at
media pieces larger than 1/2 inch in diameter near pilot.
Delayed ignition could occur. Use only round 1/2 inch
pieces near pilot.
NO NO
Figure 1. Selecting Flat Media for Pilot Cover.
Heatilator • CRAVE4836/ST, CRAVE6048/ST, CRAVE7260/ST, CRAVE8472/ST Installation Manual • 2301-970 Rev. Q • 9/15
YES YES
2. The included media placement jig, shown in Figure
2, MUST be used any time media are placed on the
burner to ensure that none end up in the burner lighting
area. Verify that the media placement jig is correctly
installed in place in the appliance. See Figure 3.
WARNING
Delayed Ignition Risk
• Place media according to instructions.
• Do NOT place media in area in front of pilot
• Do NOT place media in a position that they may
fall into area in front of pilot.
• Do NOT use any media other than the media
supplied with this fi replace.
• Do NOT exceed one layer of media on base pan.
Fireplace will not function properly.
Delayed ignition may occur.
ROCK MEDIA PLACEMENT JIG
PILOT SHIELD
BURNER RAILS (2)
BURNER
(4836/6048 MODELS)
BURNER
(7260/8472 MODELS)
Figure 2. Media Tray Components
3. The media placement jig must remain in place while
media is placed on the media tray and around the pilot
bracket.
MEDIA TRAY
59