Cirrus DESIGN SR22T Pilot Operating Handbook page 129

Cirrus Design
SR22T
e. Tire ............................................Condition, Inflation, and Wear
Clean and inspect temperature indicator installed to piston
housing. If indicator center is black, the brake assembly has
been overheated. The brake linings must be inspected and O-
rings replaced.
f. Wheel and Brakes ....... Fluid Leaks, Evidence of Overheating,
General Condition, and Security.
g. Chocks and Tiedown Ropes........................................Remove
h. Cabin Air Vent......................................................Unobstructed
8. Nose, Right Side
a. Vortex Generator ....................................................... Condition
b. Cowling.....................................................Attachments Secure
c. Exhaust Pipe ....................Condition, Security, and Clearance
d. Gascolator (underside)................ Drain for 3 seconds, Sample
9. Nose gear, Propeller, and Spinner
Keep clear of propeller rotation plane. Do not allow others to
approach propeller.
a. Tow Bar ....................................................... Remove and Stow
b. Strut........................................................................... Condition
c. Wheel Fairing ....................... Security, Accumulation of Debris
d. Wheel and Tire ..........................Condition, Inflation, and Wear
e. Propeller ...........................Check adequate Ground Clearance
f. Spinner ............................... Condition, Security, and Oil Leaks
g. Air Inlets ..............................................................Unobstructed
h. Alternator................................................................... Condition
10. Nose, Left Side
a. Landing Light............................................................. Condition
b. Engine Oil......... Check 6-8 quarts, Leaks, Cap & Door Secure
c. Cowling.....................................................Attachments Secure
P/N 13772-003
Original Issue
• Caution •
• WARNING •
(Continued on following page)
Section 4
Normal Procedures
4-7