Table of Contents Getting to know the recorder ......................2 Power key ............................3 LED indicators ..........................3 Function keys ..........................4 System icons ..........................5 Inserting a memory card .........................6 Using your recorder in a vehicle ....................7 Connecting to external devices .....................9 Connecting to your computer ....................9 Connecting to a High Definition (HD) device ...............9 Operating basics ..........................
Getting to know the recorder NOTE: The screenshots and other presentations shown in this manual may differ from the actual screens and presentations generated by the actual product. Device mount socket For the device mount. Mini-USB connector Connects to the charger or computer.
Power key Once the vehicle engine is started, the recorder automatically turns on. By default, the recording will start right after the recorder turns on. You can perform the following using the Power key: To manually turn the recorder on and off, press and hold the Power key for 2 seconds.
Function keys The device provides four function keys to control the corresponding icons displayed at the bottom of the LCD screen. The key’s function may vary on different screens. For example, the device will display four icons as shown below while continuous recording is in progress. Example: Icon Description...
System icons Various System icons on the title bar at the top of the screen provide the status information of your device. The icons displayed will vary depending on your device model and state. Example: Icon Description The REC icon blinks while recording is in progress. Displays the current time.
Inserting a memory card You must insert a memory card (may be sold separately) before you can start recording. 1. Hold the card by the edges and gently insert it into the slot with the label facing the rear side of the recorder. 2.
Using your recorder in a vehicle 1. Make sure that your car is parked on a level ground. 2. Follow the instruction below to mount your recorder in a vehicle securely. 3. Connect the car charger to the cigarette lighter. Route the cables through the top ceiling and the A-pillar so that it does not interfere with driving.
Page 9
4. When adjusting the angle of mounting, make sure that the camera’s view is parallel with the level ground, and the ground/sky ratio is close to 6/4. 5. When not using the recorder, follow the instruction below to remove the recorder from the holder.
Connecting to external devices Connecting to your computer You can connect the recorder to your computer to access data on the memory card. The Mini-USB connector is located on the right side of the device. Follow the instruction below to connect the rcorder to the computer via the USB cable (not supplied). Connecting to a High Definition (HD) device For a better viewing experience, you can connect the recorder to an external viewing device that supports the High Definition (HD) feature via a HD cable (not supplied)*.
Operating basics Turning the recorder ON and OFF Complete the installation according to the instructions in the “Using your recorder in a vehicle” section. Once the vehicle engine is started, the recorder automatically turns on. By default, the recording will automatically start in few seconds after start-up. ...
3. Select Automatic or Manual: When you select Automatic, the system will display the time zone setting screen. to select your time zone and press . The system will set the correct date and time according to the time zone setting. ...
Emergency recording By default, if an event happens, such as sudden impact, high-speed driving, an aggressive turn or an accidental crash, the G sensor will prompt the recorder to start an emergency recording. If you want to manually start an emergency recording while continuous recording is in progress, press .
Once the movements were detected and recorded during Parking mode, you will be asked to watch the video when you stop Parking mode. Follow the on-screen prompts to watch videos or resume continuous recording. The parking recordings can be found in the “Parking” category for file playback. Camera mode The recorder allows you to take a photo.
Safety camera alerts Caution: For legal reasons the safety camera function is not available in all countries. You can receive alerts to warn you about the locations of safety cameras*, which will enable you to monitor your speed through these areas. * For selected models only.
Adding safety camera NOTE: You can add a custom safety camera only when a GPS fix is established. Your recorder allows you to customise the safety camera database. You can add up to 100 custom safety cameras in your recorder. Follow the steps to configure a custom safety camera: 1.
System settings Settings Menu To customise the system settings, press NOTE: Depending on your MiVue model, certain setting options may not be available. File Playback Plays the recorded videos and photos. For more information on playback, see the "Playback mode" section. ...
Page 18
- Cruise Speed Alert: This option allows you to set the limit for cruise speed. When you drive at a cruise speed over the set value, you will receive alerts by the recorder. Parking Mode (for selected models only) Allows you to change the settings of Parking mode.
Page 19
- Emergency: Change the sensitivity level (6 levels, from Low to High) of the G sensor that allows to automatically trigger the emergency recording while continuous recording is in progress. The event recordings will be stored in the “Emergency” category. - Parking Mode (for selected models only): Change the sensitivity level (3 levels, from Low to High) of the G sensor that allows to automatically trigger the parking recording when the recorder is in Parking mode.
Installing MiVue Manager Download MiVue Manager from www.mio.com and follow the on-screen prompts to install it. Playing the recording files 1. Remove the memory card from the recorder and access the card on the computer via a card reader.
Page 21
NOTE: The Map screen may not display when the computer is not connected to the Internet or when your MiVue model does not support the GPS function. G sensor chart displays data in 3-axis waveform about the car’s shift forward/ backward (X), to the right/left (Y) and upward/downward (Z).
Page 22
: Mutes or unmutes the volume. : Adjusts the volume level. : Plays the video in full screen. Click to return to the normal view. : Displays the playback progress. You can click on a point along ...
For more information Precautions and notices For your own safety, do not operate the controls of the product while driving. A window mount is needed when using the recorder in a car. Make sure that you place the recorder in an appropriate place, so as not to obstruct the driver’s view or deployment of airbags.
Do not attempt to service the unit. There are no serviceable parts inside. Replace the unit if it is damaged or exposed to excess moisture. About the battery CAUTION! This unit contains a non-replaceable internal Lithium Ion battery. The battery can burst or explode, releasing hazardous chemicals.
Caring for your device Taking good care of your device will ensure trouble-free operation and reduce the risk of damage. Keep your device away from excessive moisture and extreme temperatures. Avoid exposing your device to direct sunlight or strong ultraviolet light for extended periods of time.
Regulatory information (CE) For regulatory identification purposes, MiVue 5 Series is assigned a model number of N467. Products with the CE marking comply with the Electromagnetic Compatibility Directive (2004/108/EC) - issued by the Commission of the European Community. Compliance with these directives implies conformity to the following European Standards: EN 301 489-1 V1.9.2 : 2011...
Page 27
Do not operate the device while driving. Using this product does not change the requirement for a driver to take full responsibility for his or her behavior. This responsibility includes observing all traffic rules and regulations in order to avoid accidents, personal injury or property damage. MiTAC Europe Ltd www.mio.com...