Save & Exit Setup; Exit Without Saving; Updating The Bios - DFI NS70-EC User Manual

Hide thumbs Also See for NS70-EC:

Table of Contents

Award BIOS Setup Utility

3.1.13 Save & Exit Setup

When all the changes have been made, highlight "Save & Exit Setup"

and press <Enter>. The message below will appear:

Type "Y" and press <Enter>. The modifications you have made will

be written into the CMOS memory, and the system will reboot. You

will once again see the initial diagnostics on the screen. If you wish to

make additional changes to the setup, press <Ctrl> <Alt> <Esc>

simultaneously or <Del> after memory testing is done.

When you do not want to save the changes you have made, high-

light "Exit Without Saving" and press <Enter>. The message below

will appear:

Type "Y" and press <Enter>. The system will reboot and you will

once again see the initial diagnostics on the screen. If you wish to

make any changes to the setup, press <Ctrl> <Alt> <Esc> simulta-

neously or <Del> after memory testing is done.

To update the BIOS, you will need the new BIOS file and a flash

utility, AWDFLASH.EXE. Please contact technical support or your

sales representative for these files.

1. Save the BIOS along with the flash utility AWDFLASH.EXE to a

floppy disk.

2. Insert the floppy disk into a floppy drive and power-on the sys-

tem. Press the <Alt> and <F2> keys simultaneously. The utility,

which works only in DOS mode, will update the new BIOS file

to the programmable flash EEPROM that is on the mainboard.

The new BIOS will permanently replace the original BIOS content

after flashing.

Save to CMOS and Exit (Y/N)? N

Quit Without Saving (Y/N)? N

Table of Contents

Ns70-el