Front Panel Connectors - DFI NS70-EC User Manual

2
Hardware Installation

2.5.17 Front Panel Connectors

SP-LED - ATX 5VSB Standby LED
This LED will light when the 5VSB power is active.
HD-LED: Primary/Secondary IDE LED
This LED will light when the hard drive is being accessed.
G-LED: Green LED
This LED will not light when the system's power is on. It will blink
ever y second when the system is in the S1 (POS - Power On
Suspend) or S3 (STR - Suspend To RAM) state.
SP-SW: ATX Power Switch
Depending on the setting in the BIOS setup, this switch is a "dual
function power button" that will allow your system to enter the Soft-
Off or Suspend mode. Refer to "Soft-Off By PWRBTN" in the Power
Management Setup (Chapter 3).
G-SW: Green Switch
This switch will allow your system to enter the Suspend mode.
RESET: Reset Switch
This switch allows you to reboot without having to power off the
system thus prolonging the life of the power supply or system.
42
Front panel
connectors (J11)
SPEAKER HD-LED
G-LED SP-LED
RESET SP-SW
P-LED G-SW