HP Pavilion x360 Maintenance And Service Manual page 50

Remove the display assembly:
1. Release the ZIF connector (1) to which the display panel cable is attached, and then disconnect the
display panel cable from the system board.
2. Disconnect the WLAN antenna cables (2) from the terminals on the WLAN module.
NOTE:
"1". The WLAN antenna cable labeled "2" connects to the WLAN module "Aux" terminal labeled "2".
3. Release the ZIF connector (3) to which the display TouchScreen cable is attached, and then disconnect
the display TouchScreen cable from the system board.
4. Release the display TouchScreen cable from the routing clip (4) built into the bottom cover.
5. Remove the three Phillips PM2.5×5.7 screws (1) and the Phillips PM2.5×3.3 screw (2) that secure the
display assembly to the bottom cover.
40 Chapter 5 Removal and replacement procedures
The WLAN antenna cable labeled "1" connects to the WLAN module "Main" terminal labeled