Removing The Front Panel Assembly; Removing The Head Phone Board - JVC UX-V30 Service Manual

UX-V30

Removing the front panel assembly

Prior to performing the following procedure, remove
the rear cover, the side panels, the cassette
mechanism assembly and the main board.
1. Disconnect the card wire from connector CN732 on
the LCD board.
2. Remove the two screws D attaching the front panel
assembly on the bottom of the body.
3. Release the two joints c on the lower right and left
sides of the body. Pull out the front panel assembly
toward the front.

Removing the head phone board

Prior to performing the following procedure, remove
the rear cover, the side panels, the cassette
mechanism assembly, the main board and the front
panel assembly.
1. Remove the plastic rivet attaching the head phone
board and release the joint d.
Plastic rivet
1-6
(See Fig.10 to 12)
(See Fig.13)
Joint d
Fig.13
G
F
Front panel assembly
Joint c
Front panel assembly
D
D
Heat sink
Main board
G
Fig.9
Tuner & function board
LCD board
CN732
Fig.10
Fig.11
Front panel assembly
Joint c
Fig.12