Front Panel Assembly; Removing The Cd Mechanism Assembly; Removing The Led Board (A) - JVC UX-V30 Service Manual

<Front panel assembly>
Prior to performing the following procedure, remove
the rear cover, the side panels, the cassette
mechanism assembly, the main board and the front
panel assembly.

Removing the CD mechanism assembly

1. Disconnect the harness from connector CN721 and
CN722, and the card wire from CN766 on the LCD
board on the back of the front panel assembly.
2. Remove the five screws M
mechanism cover to the front panel. Remove the CD
mechanism cover together with the CD mechanism
assembly.
3. Release the harness from each hook on the CD
mechanism cover.
4. Remove the five screws N
mechanism cover and the CD mechanism case.
Release the three joints g of the CD mechanism
cover and the CD mechanism case by pushing the
joint hooks inward.
5. Disconnect the card wire from connector CN603 and
the harness from CN605 on the CD servo control
board.
6. Remove the CD mechanism assembly from the CD
mechanism cover by pulling out it from the three
bosses h.

Removing the LED board (A)

1. Remove the screw O attaching the LED board (A).
CD mechanism cover
CN603
Fig.21
(See Fig.18 to 21)
attaching the CD
attaching the CD
(See Fig.21)
CD servo control board
LCD board (A) CD mechanism case
CN605
M
M
CN766
LCD board
Fig.18
N
Joint g
Joint g
N
Fig.19
Joint g
Fig.20
UX-V30
CD mechanism cover
(CD mechanism assembly)
R
Belt
Loading motor
M
CN721
CN722
N
CD mechanism cover
Loading motor
CD mechanism
case
N
Joint g
CD mechanism cover
1-9