Front Panel Assembly - JVC HX-Z1 Service Manual

Removing the
assembly
Prior to performing the following procedure, remove
the metal cover, the CD changer mechanism
assembly, the rear panel, the main board and the
bridge board / regulator board.
1. Remove the screw N attaching the primary board.
2. Disconnect the wire from connector CN231 and
CN232 on the primary board.
3. Remove the four screws O
transformer assembly.
4. Cut the tie band and detach power cord from primary
board.
REFERENCE: When disconnecting the power cord
from connector CN250 on the primary
board, remove the fixing band.
<Front panel assembly>
Prior to performing the following procedure, remove
the metal cover, the CD changer mechanism
assembly and the front panel assembly.
Removing the
assembly
1. Disconnect the card wire from connector CN33 on
the head amplifier & mechanism control board.
2. Remove the two screws P, and the screw Q
attaching the cassette mechanism assembly.
Removing the headphone board
1. Remove the screw Q attaching the wire extending
from the headphone board.
2. Remove the screw R and pull out the headphone
board backward.
power transformer
(See Fig.28, 29)
attaching the power
cassette mechanism
(See Fig.30)
(See Fig.30)
Power transformer assembly
Fig.28
Primary board
CN231, CN232
O
Fig.29
Head amplifier & mechanism control board
CN33
P
Cassette mechanism assembly
Fig.30
N
Primary board
Power transformer assembly
CN250
Band
O Cord stopper
Q
Headphone board
Q R
HX-Z1
1-13