Hilti DX E?72 Operating Instructions Manual page 8

2.5 Contact pressure safety device
The tool can be fired only when pressed fully against a firm surface with a force of at least 50 N.
2.6 Unintentional firing safety device
The tool is also equipped with an unintentional firing safety device. This prevents the tool from firing if the trigger is first
pulled and the tool then pressed against the work surface. The tool can be fired only when it is first pressed correctly
against the work surface and the trigger subsequently pulled.
2.7 Range of fasteners available for various applications
Fasteners
Ordering designation
X-U
X-C
X-S
X-CT
X-CR
X-CP / X-CF
X-FS
X-SW
X-HS / X-HS-W
X‑CC
X-(D)FB / X-EMTC
X‑EKB
X-ECH
X‑ET
X-(E)M/W/6/8 ... P8
X-DNH / DKH X-M6/8H
Cartridges
Ordering designation
5.6/16 brown
5.6/16 green
5.6/16 yellow
5.6/16 red
Application
High-strength nail for fastening on high-
strength steel and concrete in a wide range
of applications
Standard nail for fastening on concrete
Standard nail for efficient fastening on steel
Easily removable nail for fastening form-
work temporarily on concrete
Stainless steel nail for fastening in damp or
corrosive surroundings
Special fastener for timber structures on
concrete
Fastener for positioning formwork
Flexible washer fastener for fastening
plastic sheeting and thin insulating
materials to concrete and steel
Suspension system with threaded connec-
tion
Fastening clip for wire hangers
Metal conduit clip for fastening electrical
conduits or insulated pipes (hot or cold) in
water supply and heating installations
Cable clasp for fastening electric cables flat
on ceilings and walls
Bunched cable holder for fastening cables
on ceilings and walls
Fastener for plastic (PVC) electric cable
trunking
Threaded stud for temporary fastenings on
concrete and steel
Approved (ETA) DX-Kwik fastening system
use on concrete with predrilling
Color
Brown
Green
Yellow
Red
Power level
Extra-light
Light
Medium
Heavy
en
19