Glass Only Placement - Vermont Castings VFF32LI Installation & Operating Instructions Manual

Center Log #9
Mid Left Log #8
Figure 48
10. Place top front right log (#10) onto mid right log (#6) by
placing notch on bottom of log onto locating block on
log #6. Rest bottom end of log onto grate bar. Figure
49
11. Place top front left log (#11) onto mid left log (#8) by
placing notch on bottom of log onto locating block on
log #8. Rest bottom end of log onto grate bar. Figure
49
Top Front
Left Log #11
Figure 49
12. Place log #12 onto mid left log (#8) and mid rear log
LG1071
Mon SC24R logs 10 11
(#7) by placing notch on bottom of log onto locating
block on log #8. Rest right end of log onto top of log
#7. Figure 50
Log #12 (SC2430EK
Enhancement Kit)
Figure 50
LG1072
Mon SC24R log 12
20308184
LG1070
Mon SC24R logs 8 9
Top Front
Right Log #10
13. Place log #13 onto log #12 and top front right log (#10)
by placing notch on bottom of log onto locating block
on log #12. Rest bottom of log onto log #10 and center
log (#9). Figure 51
Figure 51

GLASS ONLY PLACEMENT

LG1073
Mon SC24R log 13
NOTE: Two (2) bags of glass are supplied with the VFF32
fireplace and three (3) are supplied with the VFF36 fire-
place. All of the supplied bags may be used to cover the
entire floor and burner. We advise against using additional
glass as too much can cut off the proper amount of air the
burner needs to operate cleanly. This may cause sooting.
1. Spread glass evenly in one layer over the entire floor
and burner. Be sure to use a single layer only over the
ported area so as not to impinge the flame.
2. Turn burner on and adjust glass over ported areas to
achieve an even, clean flame.
Figure 52
VFF Vent Free Fireplace System
Log #13
(SC2430EK
Enhancement Kit)
29