Table of Contents
Advertisement
VFC Vent Free Fireplace System
5. Place the left middle log #5 with the C channel locking
the front and middle log in place. Figure 27
Figure 27
6. Place the left rear log #6 by aligning the rear support
bracket to the cut out on the rear of log #6. The left side
will also align with the channel cut into log #5. Figure
28
Figure 28
26
LOG AND MEDIA PLACEMENT
7. Place the top center log #7 by aligning the notch from
log #3 to the bottom. The front edge of the log #7 will
rest on the front grate horizontal bar. Figure 29
Figure 29
Log placement complete.
GLASS ONLY PLACEMENT
NOTE: Two (2) bags of glass are supplied with the fi replace.
Both bags may be used to cover the entire fl oor and burner.
We advise against using additional glass as too much can
cut off the proper amount of air the burner needs to operate
cleanly. This may cause sooting.
1. Spread glass evenly in one layer over the entire fl oor
and burner. Be sure to use a single layer only over the
ported area so as not to impinge the fl ame.
2. Turn burner on and adjust glass over ported areas to
achieve an even, clean fl ame.
Figure 30
20308011
Advertisement
Table of Contents
