Inserting Batteries; Connecting To A Pc; Standing Up/Mounting The Station - HomeMatic WDC7000 Operating Manual

Inserting batteries

Remove the battery compartment cover and insert four Mignon cells, 1.5 V, alkaline type
LR6 into the battery compartment, observing the correct polarity as per the correspon-
ding diagram. Reclose the battery compartment.

Connecting to a PC

If the station is to be connected to a PC, connect the supplied USB cable featuring a
mini USB socket to the USB interface on the WDC7000. Connect the other end of the
cable to a USB interface on the PC (refer also to Section 10).

Standing up/Mounting the station

The weather station can either be mounted on a vertical surface (wall) using the attach-
ment eye or stood on an even horizontal surface using the tabletop stand.
The tabletop stand is mounted as follows, with the help of the hexagon socket screws
and hexagon wrench supplied:
1. Remove the base support cover:
48
First unclip it at the top, ease it all the way down and
then remove it.
2. Latch the base support onto the clip
on the glass base and sit it down on
the two screw domes.
3. Use the hexagon wrench and two
hexagon socket screws supplied to
screw the base support onto the glass
base. When doing this, make sure that
the lighting cable from the device base
is routed to the side as shown in the
photo, so it does not become pinched.
4. Attach the weather station to the clips
on the base support and swivel it onto
the base support until the screw do-
mes sit properly in the corresponding
receptacles on the weather station.
Caution!
Do not let go of the weather
station until the two hexagon
socket screws have been
inserted (see the next step). When
holding the weather station, do not
touch the display. Only hold the wea-
ther station by its surround.
49