Table of Contents
Advertisement
EN
ENGLISH
5. Plug battery connector into machine
connector. (Figure 4)
FIG. 4.
6. Double check all connections before closing
battery compartment.
7. To ensure a full charge for first time use,
batteries may need charging before operating.
See CHARGING BATTERIES on page 9.
SQUEEGEE KIT INSTALLATION (OPTIONAL)
See page 4 for available optional kits.
NOTE: Kit installation is made easy if batteries
are not installed. However, kit can be installed
with batteries in place.
1. Remove vacuum bags and/or empty
recovery tank.
2. Tip machine on backside. Only if batteries
are removed from machine.
3. Remove two unused squeegee mounting
screws from bottom of machine.
4. Install squeegee mounting bracket as shown.
Secure with screw and washers that you
removed. (Figure 5)
FIG. 5.
5. Fasten squeegee bracket to mounting
bracket. Use two slide pins provided. Stand
machine upright. (Figure 6)
6
Home
6. Insert spacer through hole in pedal then
position pedal between two holes in squeegee
bracket. Secure with hardware provided.
(Figure 7)
7. Position pedal between two L–brackets at
rear of machine and secure with slide pin.
(Figure 8)
8. Attach squeegee assembly to bracket as
shown and secure with two thumb screws.
(Figure 9)
Find...
Go To..
FIG. 6.
FIG. 7.
FIG. 8.
Typhoon (8–96)
Advertisement
Table of Contents
