Machine Installation - Tennant V-WD-16B Operator's Manual

OPERATION
EN

MACHINE INSTALLATION

UNCRATING MACHINE
Carefully check carton for signs of damage. Report
damages at once to carrier.
Check Machine Contents to ensure package is
complete. Contact distributor for missing items.
Machine Contents:
1 - Battery Cable #130364
4 - Battery Post Caps #45962
4 - Black Battery Boots #611221
1 - 3m (10 ft) Vacuum Hose #160481
1 - 145 cm (57 in) Vacuum Hose #1014026
1 - Paper Bag #1068846
1 - Cloth Bag #900105
2 - 12VDC 105AH Batteries #578426 (included with
machine PAC #9007471)
1 - Battery Charger, 24DC/11A 120V #1073638
(included with machine PAC #9007471)
NOTE: Squeegee and Accessory Tools Kits are
optional, they must be ordered separately (See
OPTIONS section).
INSTALLING BATTERIES
NOTE: If planning to install Optional Squeegee Kit, wait
to install the batteries until kit is installed
(See ATTACHING OPTIONAL SQUEEGEE KIT).
WARNING: Fire Or Explosion Hazard.
Batteries Emit Hydrogen Gas. Keep Sparks And
Open Flame Away. Keep Battery Compartment
Open When Charging.
FOR SAFETY: When servicing machine, wear
protective gloves and eye protection when
handling batteries or battery cables. Avoid contact
with battery acid.
Recommended Battery Specifications:
Two 12 volt 105/130 amp hour deep cycle batteries.
Maximum battery dimensions are 340 mm (13.5 in) L x
180 mm (7 in) W x 250 mm (10 in) H.
1. Turn ON/OFF switch to off.
ATTENTION: Make sure tanks are empty before
opening.
6
2. Open battery compartment, unlatch lower latches
and carefully tilt upper housing backwards to floor.
Remove loose battery cables at bottom of
compartment (Figure 1).
3. Carefully install batteries into compartment and
arrange battery posts as shown. Connect the
battery cables to the battery posts as shown, RED
TO POSITIVE & BLACK TO NEGATIVE. Use the
battery post covers and rubber boots supplied
(Figure 2).
(+)
(- )
ATTENTION: Do not drop batteries into
compartment. Battery and machine housing
damage may result.
4. Apply a light coating of non- metallic grease or
protective spray on the cable connections to
prevent battery corrosion.
ATTACHING OPTIONAL SQUEEGEE KIT
NOTE: Kit installation is made easy if batteries are not
installed. However, kit can be installed with batteries in
place.
1. Remove vacuum bags and/or empty recovery tank.
2. Tip machine on backside - only if batteries are
removed from machine.
FIG. 1
(+)
(- )
FIG. 2
V- WD- 16B / V- WD- 61B (06- 2014)