Mode Setting; Input/Output Specifications - Sony XC-HR90 Technical Manual

It is recommended that you make a test under the
conditions you will operate the camera before actually
using it.
Input/Output
Specifications
External HD/VD Input
Specifications
Note that input outside the specified ranges can lead to
internal reset instability and malfunction of the RS-
232C communication.
However, when you input an external HD/VD phase
signal in all modes, the video out signals are output
about 1 H later than the external VD.
During normal operation (30 fps mode)
HD phase: 33.67 µ sec/37.32 µ sec (binning OFF/ON)
VD phase: 33.33 m sec/18.47 m sec (binning OFF/ON)
During normal operation (15 fps mode)
HD phase: 67.34 µ sec
VD phase: 66.66 m sec/33.33 m sec (binning OFF/ON)
continuous
During restart/reset or external trigger shutter
mode operation
HD phase: 33.67 µ sec (30 fps normal), 37.32 µ sec (30
fps binning), 67.34 µ sec (15 fps normal/
binning) continuous
VD phase: VD (reset) only timing where the HD phase
is within range shown above.

Mode Setting

External HD/VD Output
Specifications
HD
VD
The amplitude level is the typical value when

terminated with 10 kΩ. External HD and VD can be
output when you set the HD/VD signal input/output
switch of the Mode setting DIP switches to INT
(down position).
The voltage and pulse width used are as measured at

pin 6 (HD) and pin 7 (VD) of the 12-pin multi-
connector on the rear panel.
WEN Output Specifications
990 H (Binning OFF)
495 H (Binning ON)
The amplitude level is the typical value when

terminated with 10 kΩ. The pulse width is undefined
during partial scan mode, but WEN rising edge is
always synchronized with internal VD at the start of
image output.
4.0V
0 – 0.6V
4.0V
0 – 0.6V
4.0V
0 – 0.6V
10