Disabling And Deleting The Mastercode - Kwikset SmartCode 912 Programming And Troubleshooting Manual

D

Disabling and Deleting the Mastercode

1. Keep door open. Press and HOLD the Program button until the keypad
fl ashes green (about 5 seconds).
2. Press Lock button once.
3. Enter Mastercode.
Technical Support
1-866-863-6584
www.kwikset.com
4. Press Lock button once.
5. Re-enter Mastercode.
6. Press Lock button once.
If programming is successful, the keypad will flash green once with
one beep.
If programming is unsuccessful, the keypad will fl ash red three times with
three beeps. Make sure the Mastercode has been enabled before trying
to disable it. Attempt the procedure again, making sure to enter the same
Mastercode in steps 3 and 5.
7. Make sure switch #3 is on, and press the Program button once. If you
don't immediately hear three beeps and see the keypad fl ash green
three times, the Mastercode is disabled.
Note: The lock will time out after fi ve seconds.
5 / 11
62813 / 01
©2015 Spectrum Brands, Inc.