Sony MCC-3000MT Instructions For Use Manual page 2

WARNING
To reduce the risk of fire or
electric shock, do not expose this
apparatus to rain or moisture.
To avoid electrical shock, do not
open the cabinet. Refer servicing
to qualified personnel only.
No modification of this equipment is allowed.
Symbols on the products
Refer to the operating instructions
Follow the directions in the
operating instructions for parts of
the unit on which this mark
appears.
This symbol indicates the
equipotential terminal which brings
the various parts of a system to the
same potential.
This symbol indicates the
manufacturer, and appears next to
the manufacturer's name and
address.
This label is located on the top panel of the
unit.
See page 18 of these instructions for details
about how to attach the connector covers.
For the customers in the U.S.A.
This equipment has been tested and found to
comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference when the equipment is operated
in a commercial environment. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instruction
2
manual, may cause harmful interference to
radio communications. Operation of this
equipment in a residential area is likely to
cause harmful interference in which case the
user will be required to correct the
interference at his own expense.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate
this equipment.
All interface cables used to connect
peripherals must be shielded in order to
comply with the limits for a digital device
pursuant to Subpart B of Part 15 of FCC
Rules.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) this device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
For the customers in Canada
This Class A digital apparatus complies with
Canadian ICES-003.
For the customers in Canada
This unit has been certified according to
Standard CAN/CSA-C22.2 No.60601-1.
Important safeguards/notices for use in the
medical environments
1. All the equipments connected to this unit
shall be certified according to Standard
IEC60601-1, IEC60950-1, IEC60065 or
other IEC/ISO Standards applicable to
the equipments.
2. Furthermore all configurations shall
comply with the system standard
IEC60601-1-1. Everybody who connects
additional equipment to the signal input
part or signal output part configures a
medical system, and is therefore,
responsible that the system complies
with the requirements of the system
standard IEC60601-1-1.
If in doubt, consult the qualified service
personnel.
3. The leakage current could increase
when connected to other equipment.