Polaris ATV 2002 Owner's Manual page 113

MAINTENANCE AND LUBRICATION
Lubrication
Oil Filter and Change (Cont.)
(4-Stroke models with an external oil tank)
11. Lubricate O-Ring on new filter with a film of new engine oil.
Check to make sure the O-Ring is in good condition. Also make
sure the O-ring from the old filter is not still on the engine.
12. Install new filter and tighten by hand 1/2 to 3/4 turn after gasket
contact.
13. Approximately 1 cup of engine oil will remain in the crankcase.
To drain, remove drain plug found on lower right side of
crankcase. NOTE: The sealing surfaces on the drain plug and
crankcase should be clean and free of burrs, nicks or scratches.
14. Reinstall drain plug.
15. Remove dipstick and add the amount of oil indicated in your
Owner's Manual Supplement. Reinstall dipstick. NOTE: If sump
is not drained, add about 1 3/4 quarts initially.
16. Place gear selector in
neutral and set parking
brake.
17. Start engine and let it
idle for one to two
minutes. Stop engine
and inspect for leaks.
18. Re-check oil level on
the dipstick and add oil
as necessary to bring the
level to the upper mark
on the dipstick.
19. Dispose of used filter
and oil properly.
110
Dipstick
Filter