Picture Tube Removal - Sony TRINITRON CPD-G200 Service Manual

CPD-G200

2-4. PICTURE TUBE REMOVAL

• REMOVAL OF ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT,
after removing the anode.
• REMOVING PROCEDURES
a
1
Turn up one side of the rubber cap in
the direction indicated by the arrow a.
• HOW TO HANDLE AN ANODE-CAP
1
Don't scratch the surface of anode-caps with shartp shaped mate-
rial!
2
Don't press the rubber hardly not to damege inside of anode-caps!
A material fitting called as shatter-hook terminal is built in the
rubber.
3
Don't turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or damage the rubber.
2
Degaussing coil assembly
8
Neck assembly
10
Deflection yoke
11
CN2
Four screws
6
(Tapping screw 5)
Anode cap
1
Two degaussing coil holders
13
Cushion
2
Using a thumb pull up the rubber cap
firmly in the direction indicated by the
arrow b.
A board
Two extention springs
9
CN303
2 pin
CN601
8 pin
CN904
Bezel assembly
Picture tube
7
b
2-3
Two screws
3
(+BVTP 4 x 16)
Base assembly
5
GND
Two screws
4
(+BVTT 4 x 8)
Two degaussing coil holders
12
Anode Button
3
When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling up it in
the direction of the arrow c.
c