Picture Tube Removal - Sony CPD-2001G Service Manual

2-4. PICTURE TUBE REMOVAL

• Remove the A and D boards (Refer to 2-3).
Four screws
4
(Tapping screw 5)
Picture tube shield
5
1
• REMOVAL OF ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT, after
removing the anode.
• REMOVING PROCEDURES
a
1 Turn up one side of the rubber cap in
the direction indicated by the arrow a.
• HOW TO HANDLE AN ANODE-CAP
1 Don't hurt the surface of anode-caps with shartp shaped
material!
2 Don't press the rubber hardly not to hurt inside of anode-caps!
A material fitting called as shatter-hook terminal is built in the
rubber.
3 Don't turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or hurt the rubber.
Neck assy
2
Deflection yoke
3
Anode cup
Picture tube
6
b
2 Using a thumb pull up the rubber cap
firmly in the direction indicated by the
arrow b.
Cushion
3 When one side of the rubber cap is
2-2
CPD-2001G
c
Anode Button
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling up it in the
direction of the arrow c.