Picture Tube Removal - Sony TRINITRON PVM-14N1A Service Manual

2-5. PICTURE TUBE REMOVAL
2. Connector panel
5. CA board (14 inch)
CB board (20 inch) S
6. Deflection yoke
7. Four screws N\® a"
(Tapping screw 5) —¢ |
Pele |
|
|
|
|
|
Remove the two claws
20 inch only
®
8. Picture tube
shield —
9. Picture tube !
1. Anode cap
Cushion
e REMOVAL OF ANODE-CAP
14 inch only
a eCBholde | Fo "I
|
|
|
|
| 4. A board
| |
|
|
|
tube, after removing the anode.
«REMOVING PROCEDURES
1. Turn up one side of the rubber cap 2. Using a thumb pull up the rubber cap
in the direction indicated by the arrow firmly in the direction indicated by the
®.
arrow ©.
«HOW TO HANDLE AN ANODE-CAP
1. Don't hurt the surface of anode-caps with sharp shaped material!
2. Don't press the rubber hardly not to hurt inside of anode-caps!
A material fitting called as shatter-hook terminal is built in the rubber.
3. Don'tturn the foot of rubber over hardly!
The shatter-hook terminal will stick out or hurt the rubber.
When one side of the rulber cap is
separated from the anodebvitton, the
anode-cap can be remove by turning
up the rubber cap and puing up it in
the direction of the arrow ©.