Preparation After Storage - Arctic Cat 400 3in1 Owner's Manual

Preparation after storage

Taking the ATV out of storage and
correctly preparing it will assure
many kilometers and hours of trou-
ble-free riding. Arctic Cat recom-
mends the following procedure to
prepare the ATV:
1. Clean the ATV thoroughly.
2. Clean the engine. Remove the
cloth from the exhaust system.
3. Check all control wires and ca-
bles for signs of wear or fraying.
4. Change the engine/transmission
oil and filter.
5. Charge the battery; then install.
Connect the battery cables making
sure to connect the positive cable
first.
6. Check the entire brake system
(fluid level, pads etc.), all controls,
headlights, taillight, brake light and
headlight aim.
7. Check the tire pressure.
8. Take care that all screws, nuts
and holding components are
������ �� � ��
��������������� ��
������� ��� � ��� ����������
���������� ������������
ENGLISCH
tightened properly.
9. Make sure the steering moves
freely and does not bind.
10. Check the spark plug. Clean or
replace as necessary.
50
���������� ����������� ��������
21.05.2006, 14:50 Uhr
Page 48
�����������������